General Information About KeeGuard® Fall Protection
Put Your Trust In KeeGuard
KeeGuard is a modular, free standing roof edge railing system that does not penetrate the roof membrane. Being free-standing, KeeGuard can be used for roof edge fall protection, walkway demarcation, and stairwell and open lift shaft fall protection. It can also be used to fulfill a variety of additional safety requirements. KeeGuard is fully tested and meets or exceeds current safety requirements.

The KeeGuard system is supplied in pre-fabricated kit form with an integral toe board fixing and minimum number of assemblies for ease of installation. Its light counterweight system allows installers to erect the system with minimal effort, thus saving time and money where it counts most --- on site.

There's no need for drilling or penetration of the roof membrane. For added safety, all areas that come in contact with the roof have a protective anti-slip rubber pad fitted.

KeeGuard Roof Edge Railing System
Safety
The KeeGuard system not only meets but exceeds current safety requirements for guard rails.
  • KeeGuard assemblies use fittings that are TÜV tested and approved
  • Integral toe board fixing holes to allow full compliance with OSHA
  • Assemblies that come in contact with the roof membrane are fitted with an anti-slip rubber pad
  • Works on the well-proven counterweight principle
KeeGuard Roof Edge Raling is easy to install

Versatility
The KeeGuard pre-fabricated design, utilising the lightweight modular counterweights, allows maximum versatility on site.

  • Sections can be taken down, added to and re-erected on site
  • Can be used for walkway demarcation, open liftshaft and stairwells, fall protection around roof top equipment and other safety applications
  • Adaptable to almost all variations of flat roofs, be they circular, square, rectangular or multilevel
  • Available from pur warehouse or through our national chain of authorized installers
Durability
Maintenance free and truly reliable, you can depend on KeeGuard roof edge protection.
  • Corrosion resistant - fittings galvanized to ASTM A153 finish and pipe galvanized to ASTM A53 on all assemblies
  • Featuring case-hardened steel grub screws with KeeKoat® protection providing outstanding corrosion resistance
  • Kee Klamp® fittings, manufactured to the requirements of ASTM A47-77-32510, provide strong, rigid, maintenance free connections

Simplicity
The KeeGuard modular design takes the complexity and high cost out of roof edge protection - for good.

  • Minimum components for ease of fitting
  • Adjustable uprights allow up to 11 degree raking from vertical movement
  • No drilling, special anchoring or penetration of roof membrane required
  • No welding, bending or threading required on site
  • No special tools needed to complete a reliable and safe rooftop railing installation